ecodry KA-MT 1-4 Series Adsorption Air Dryers

Model(s): KA-MT 1, KA-MT 2, KA-MT 3, KA-MT 4

Features & Benefits of Parker Zander KA-MT 1-4 Series Air Dryers:
• Pressure dew points down to -70 °C
• Volume flows up to 35 m³/h @ 7 barg (100 psig)
• Pre- and after filters installed as standard
• Fully dewpoint dependent control is possible as an option
• Remaining oil content of 0,003 mg/m³
• Highest quality air
• Energy efficient
• Dry air means zero corrosion

Energy Savings
Where an application calls for a unit able to cope with variations in operating pressure and load, the installation of a dew point sensor at the outlet of the dryer is available as an option. In such an operating mode, the changeover cycle between vessels only takes place when required, and is dependent on the required dew point being achieved. Only upon reaching this adjustable set dew point, does changeover to the regenerated vessel occur. This feature enables the drying phase to be lengthened and thus avoids the unnecessary use of purge air for regeneration and consequently provides energy savings.

Compressed air can be selectively dried to meet a dew point of -25°C down to -70°C.

Sizing and Model Selection
To ensure quoted air purity performance is met, a compressed air dryer must be sized correctly for minimum operating pressure, maximum inlet temperature and maximum inlet flow rate using the correction factors found in the Product Information Sheet.

For more information or a detailed discussion about your specific requirements please contact us at 727-835-0649 or Toll Free at 800-761-4298.